Check the Configuring Video Ports section in the user's manual for details. This might be due to that the monitor(s) support higher resolutions than what the dock is able to support. Make sure that the video cable is tightly secured to the video port in the dock and that the display output setting of the monitor is set to the correct mode.Check the Using your dock for the first time section in the user's manual to re-connect the dock to the computer. Make sure the computer is connected with the dock.If the AC adaptor still does not power the dock, you should contact dynabook Support.If the cord is frayed or damaged, it should be replaced, while if the terminals are soiled, they should be cleaned with a clean cotton cloth. Check the condition of the cord and terminals.Check the connections to make sure that the power cord/adaptor is firmly connected to the dock and a working power outlet.If another device is connected to a port on the dock and the computer goes into standby/sleep/hibernation mode, that device does not function. To change the default settings, you might need to adjust the audio settings in Windows manually, as described in this section. When you undock the computer, the audio ports on the computer are re-enabled automatically. Upon connection, the audio port on the dock might become enabled and the audio ports on the computer disabled. However, you cannot use the audio ports on the docked computer and on the dock at the same time. You can play back or record audio either through the audio port of the dock or the docked computer. You will exit the software by clicking this button It allows you to configure the settings of this software. You can choose to remove the selected devices or all. It shows the status/information of the approved devices. Thunderbolt Networking is only available while there is a peer-to-peer connection between the computers. It allows you to select the device approve status (actions the same as Approve Attached Devices). This item also pops up when new devices are plugged in. It allows you to select the device approve status. You can also open Approve Thunderbolt Devices by clicking the Connected or Not connected button. Users can check the device information, connection status and power mode here. It allows you to view all Thunderbolt devices attached to the computer. Launch the Thunderbolt Software by right-clicking the icon in the system tray to configure the settings as desired.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |